刻录结束失败。无法封盘（PMA更新故障、无法进行光盘一次刻录的结束动作）

IsaacZ

参考：

PMA Update Failure Please Help - Club MyCE
http://club.myce.com/f44/pma-update-failure-please-help-107315/

Program Memory Area Update Failure

A PMA Update error, or Program Memory Area Update Error, occurs when the CD or DVD tries to close off the session but can't write the updated TOC information to the Program Memory Area.

The PMA area is the 'Program Memory Area' on the media. When you begin writing to a disc, in Track-At-Once mode the Lead-In is reserved, but not written too as yet, as the data has yet to be written to the disc. And the Lead-in contains information as to where the data is located on the disc so that it can be retrieved later when you go to read the disc.

Till the Lead-In is written, this information is contained in the PMA on the disc. There is a limited number of times that you can write to the PMA, but normally it's impossible to fill that area up before you have filled up the disc.

The problem occurrs during stress testing. OPC script (>95 times) on a CD-R disk. Stress test reports Program Memory Area Update Failure when attempted to calibrate over 95 times.

When you are unable to write to the PMA area, it's normally caused by poor media, dust on the optical head, recording software problems, old firmware on the recorder, or a recorder in need of alignment. But 90% of the time its media related. （IsaacZ译：当PMA区无法写入，通常是因为光盘介质低劣、光头染尘、刻录软件问题或者刻录机需要调整。但是90%的情况下与光盘介质相关。）

Can also be caused by not enough memory for the burn program to use. Give more buffer for the burn program? Empty Temp files directory? Dont run other programs at the same time as you are burning the disk. Run a lens cleaning CD on the drive just in case.（IsaacZ译：也有可能因为程序可用内存不足。尝试为刻录程序开辟更大的缓冲区？清空系统临时文件夹？刻盘时不要运行其他程序。以防万一，用光驱清洁碟片清洁一下光头。）

提问者总结：

Thanks for replying. I have it working now just needed an update

                               
登录/注册后可看大图

（现在已经恢复正常——只是需要更新一下。）

chnxn

我觉得楼上就是答案了。
此外，直接对烧或直接刻录可能占用更多内存，所以还是先刻成镜像文件为好。

1098322709

回复 5# swswgaoyu

dekydeky96

谢谢热心的楼主

IsaacZ

谢谢热心的楼主
dekydeky96 发表于 2010-1-19 02:53

                               
登录/注册后可看大图

我们是跟帖的，你才是“楼主”，嘻嘻

黑马

前几天我也遇到过，我用Winavi重新转换一下就好了。具体什么原因就不知道了。